Following on from the bonnet enquiry, I have the facility to cut and punch aluminium. Is this of use to anyone? I could supply cut to size panels fully punched with all the holes in the correct position. I will make a set for my bus in a month or so but wonder if it is of use to others. Happy to make a few of the more susceptible to damage panels (based on the dents on mine) for stock. We can also, according to my fabricator, run the flat moldings through our punch to get the correct position of the fixing holes if this is available in long lengths and someone can tell me where to get them

Any thoughts

David Colin

My bus number (if any): RML 2276 M1001 T806

I'd be interested in beading strips that go on the rear.
ceiling panels for front corners have had me stumped also....

My bus number (if any): 1842